A potent PI3K inhibitor
GSK1059615 is inhibitor of pan-PI3K with IC50 values of 0.4nM, 0.6nM, 5nM, 2nM and 12nM for PI3Kα, P13Kβ, P13Kγ, P13Kδ and mTOR, respectively [1].
GSK1059615 is a potent and reversible inhibitor of P13K. It also has inhibition efficacy to the oncogenic mutants of PI3Kα. The thiazolidinedione ring of GSK1059615 forms an interaction with the catalytic lysine (Lys833) within the ATP-binding pocket. In cellular assay, GSK1059615 is reported to induce G1 arrest and apoptosis in a variety of cell lines. Among these, the breast tumor cells display more sensitive. Moreover, GSK1059615 significantly suppresses tumor growth and increases plasma insulin levels in xenograft mice [1, 2].
参考文献:
[1] Carnero A. Novel inhibitors of the PI3K family. 2009.
[2] Knight S D, Adams N D, Burgess J L, et al. Discovery of GSK2126458, a highly potent inhibitor of PI3K and the mammalian target of rapamycin. ACS Medicinal Chemistry Letters, 2010, 1(1): 39-43.
Kinase experiment: | The measurement of the GSK1059615-dependent inhibition of the PI3Ks is accessed using a HTRF based PI3K profiling assay kit. 400 pM enzyme is used in PI3Kα and δ assays, 200 pM in PI3Kβ assays, and 1 nM in PI3Kγ assay. In addition, the PI3Kα, β, and δ assays are run with 150 mM NaCl and 100 μM ATP, while the PI3Kγ assay is run with no NaCl and 15 μM ATP. All reactions are run at 10 μM PIP2. GSK1059615 is serially diluted (3-fold in DMSO), and 50 nL is transferred to a 384-well low-volume assay plate. PI3K Reaction Buffer is prepared by diluting the stock 1:4 with de-ionized water. Freshly prepared DTT is added at a final concentration of 5 mM on the day of use. Enzyme addition and GSK1059615 pre-incubation are initiated by the addition of 2.5 μL of PI3K in reaction buffer. Plates are incubated at room temperature for 15 min. Reactions are initiated by addition of 2.5 μL of 2× substrate solution (PIP2 and ATP in 1× reaction buffer). Plates are incubated at room temperature for one hour. Reactions are quenched by the addition of 2.5 μL of stop solution. The quenched reactions are then processed to detect product formation by adding 2.5 μL of Detection Solution. Following a 1-hour incubation in the dark, the HTRF signal is measured on the Envision plate reader set for 330 nm excitation and dual emission detection at 620 nm (Eu) and 665 nm (APC). The IC50 value is then obtained. |
Cell experiment: | Cells are plate at a density of 1×104 cells per well in clear flat-bottomed 96-well plates and incubated overnight. Then, GSK1059615 is added and the plates are incubated for 30 min. At the end of incubation, media is aspirated from the plates, and the plate is wash once with cold PBS. 80 μL MSD Lysis buffer is added into each well and the plates are incubated on a shaker at 4°C for at least 30 min. For Akt duplex assay, plates are washed with 200 μL/well wash buffer for 4 times and tapped on paper towel to blot. Then, 60 μL lysates is added to each well and the plates are incubated on shaker at room temperature for 1 hour. After another 4 times washing, antibody is added (25 μL per well) and the plates are incubated on shaker for 1 hour and washed again. Finally, Read Buffer is added (150 μL per well) and the plates are read immediately. IC50 values are then obtained. |
参考文献: [1]. Carnero A. Novel inhibitors of the PI3K family. Expert Opin Investig Drugs. 2009 Sep;18(9):1265-77. | |
动态评分
0.0